| To: | "Kenneth Brown" <kbrown@trmx3.dot.ca.gov>, <triumphs@Autox.Team.Net> |
|---|---|
| Subject: | Re: Mystery Pistons and the Dreaded DPO |
| From: | "Bill and Sal Birney" <birneybs@onaustralia.com.au> |
| Date: | Thu, 30 Jan 1997 21:01:05 +1100 |
> The problem is the pistons measure a diameter of 2.922" which is about > .015" less than what is listed in the Bentley Shop Manual (page 103, sec > 12.17.13). Does anyone know of any LBC that use the 2.922" pistons? Well it's not an exact match, however these could be oversize 1296 cc spitfire pistons (2.900 bore), these would match up to the little ends, however I don't know about piston height, a suggestion. Bill and Sal Birney '70 GT6+ (RHD) '67 Spitfire MkII (restoration) '69 Spitfire MkIII (Sal's, in queue) birneybs@onaustralia.com.au |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Steering wheel<32EF8251.7E94@kiruna.se>, Richard Jackson |
|---|---|
| Next by Date: | Re: Put a GT6 motor in a Spit?/Gearbox Swap, Bill and Sal Birney |
| Previous by Thread: | Mystery Pistons and the Dreaded DPO, Kenneth Brown |
| Next by Thread: | The redlines are here!, Joe Merone |
| Indexes: | [Date] [Thread] [Top] [All Lists] |