> A while back I dropped my distributor on the concrete and it landed on the
> vacuum unit. I don't think it hurt the distributor, and only (very
> slightly) changed the tilt of the big vacuum unit. How do I go about
> verifying that it's not hurt?
Connect a timing light, a vacuum gauge and a source of vacuum (like a MityVac).
Let the engine idle, and watch the movement of the timing mark under the light,
as you apply vacuum to the module. You can carry this to any level you choose,
but if it moves at all, chances are that the unit is fine.
Also check that the module does not leak vacuum.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|