triumphs
[Top] [All Lists]

[TR] Triumphs Digest, Vol 4, Issue 16

Subject: [TR] Triumphs Digest, Vol 4, Issue 16
From: jerryvv at roadrunner.com (Jerry Van Vlack)
Date: Fri, 17 Jun 2011 17:57:03 -0400
References: <mailman.4598.1308264678.3301.triumphs@autox.team.net><D9510387-40D3-4AB4-B0EE-1045C03F7EAA@telus.net> <005c01cc2d2d$692da8c0$0301a8c0@randall>
I guess since I brought that subject up I should add to what I said. I too 
ran an old TR4 that I had for a few months on solid wheels with ww studs and 
lived to see the next day but I would not recommend anyone do this just 
because I lived through doing it. That car was sold a long time ago. In 1998 
I changed my TR4A from wires to Panasports. I planned to change the studs 
this time but I wanted to see how these new wheels and tires looked on my 
car. The front fit and there was some thread engagement but when I tried the 
back I was only able to get about 2 threads to engage using the supplied 
Panasport wheel nuts. Why the front to back difference I don't know, perhaps 
the front ww studs are a bit longer. I did not lower the car to the ground 
with the Panasports on the back for fear they would pull off the studs.

Moral is this. Maybe you can get away with it using stock TR wheels but you 
can not using Panasport wheels and I suspect the other styled wheels are the 
same. The hubs of the wheels are too thick to allow it. I would not endorse 
it with stock wheels either.............but I did it when I didn't know any 
better.

JVV

----- Original Message ----- 
From: "Randall" <TR3driver at ca.rr.com>
To: "'Don Spence'" <dkspence at telus.net>; <triumphs at autox.team.net>
Sent: Friday, June 17, 2011 4:30 PM
Subject: Re: [TR] Triumphs Digest, Vol 4, Issue 16


>> If you are changing from wires to solid wheels, you really need to
>> replace the wheel studs with the longer ones meant for solid wheels.
>
> While I agree, I am curious : Has anyone actually had a short stud fail 
> when
> used with the steel wheel nuts (and not under racing conditions) ?
>
> I ran a lot of miles with steel wheels on wire wheel studs and never had 
> any
> problems.  Of course I'd never suggest doing that to anyone else!
>
> -- Randall

<Prev in Thread] Current Thread [Next in Thread>