datsun-roadsters
[Top] [All Lists]

RE: stock wheels, which tires?

To: <datsun-roadsters@autox.team.net>
Subject: RE: stock wheels, which tires?
From: Dave Dearinger <daved@mdon-line.com>
Date: Thu, 27 Oct 2005 13:54:43 -0700
I think that 185/70R14 tires are usually a good size and aspect ratio for 
non-spirited driving. Cheap and easily available.

When I bought my roadster it had three different models of Yokohama 
185/70R14 tires installed on the stock wheels. I replaced those tires an 
axle set at a time with 185/60R14's. I can't recall exactly what 
manufacturers' name is on the tire they were cheap at Les Schwab, ~$50 
each, and the tires are rated A for traction and temperature. I think they 
have a treadwear rating of 120, but I'm not exactly sure. First I replaced 
the two odd tires, having the new tires installed on the front axle, and 
the matching pair of Yokohama's installed on the rear axle. I soon replaced 
the Yokohama's on the rear soon after realizing that even though the old 
tires  had a good amount of tread left the tires were too old and the 
rubber compound had become hard and slippery. After replacing the rears 
with the smaller diameter tires I noticed that my engine RPM's at 50mph in 
fourth gear changed from ~3000 to ~3300. I would have preferred to go with 
a 195-60R14 to get a tire that was the same diameter as the tires I was 
replacing but the stock wheel rims are not wide enough to safely use a tire 
that wide. I considered going with a 175/50R14, but those tires would have 
been too short for driving at highway speeds. Also the 175/50's are a 
difficult to find tire size and I probably would have had to special order 
tires of that size from Europe. Although I have been considering them again 
now that I have a housemate who auto-x's his RX-7 and would enjoy the 
company at the track.
There are so many variables in fitting tires and wheels to cars that it can 
be difficult to predict what will fit a particular setup. If a person was 
careful about selecting the right model of wheel, with an appropriate 
offset, and backspacing could fit a tire that would be normally considered 
too large to fit the car. Sometimes it is even a matter of particular model 
of tire offered by a manufacturer that will mean the difference of wether 
the tire can be fitted to the car.

-Dave Dearinger
-1966 1600

At 12:07 PM 10/27/2005 -0700, Pete Peters wrote:

>I believe I have no-name 185x65-14 retreads on my stock rims (not home right
>now). IIRC, Discount Tire told me 185x60 would be the largest tire I could
>fit on those rims.
>
>Pete




<Prev in Thread] Current Thread [Next in Thread>