Rob Mann, and felow members, thanks.
Rob thanks for the quick response, it was less than 3 minutes, and you wrong,
the U Joint isn't bad, it was falling off. I put the car up, and crawled under
to note one bolt was missing, so since it looks tough to get in from below, I
attacked from above. With a finger along the edges, I found two bolts missing.
So hardware store up the street is closed, I will get at this tommorrow. I
assume starting the bolts from above, and tightening from underneath is the
correct way to get at them? I have the new Datsun book, but it didn't have any
details on tightening up those bolts.
Again, thanks for the quick help.
_________________________________________________________________
The New Busy is not the old busy. Search, chat and e-mail from your inbox.
http://www.windowslive.com/campaign/thenewbusy?ocid=PID28326::T:WLMTAGL:ON:WL
:en-US:WM_HMP:042010_3
________________________________________
Datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $16.00
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|