healeys
[Top] [All Lists]

Re: BJ8 Choke cables

To: Richard Bittmann <edmyed@harbornet.com>
Subject: Re: BJ8 Choke cables
From: Bob Spidell <bspidell@comcast.net>
Date: Thu, 19 Jan 2006 17:48:59 -0800
I made a retaining clip from a small binder clamp.  I trimmed the bottom 
of the clamp, and drilled
a hole large enough to clear the set screw for the center cable.  It 
works, and almost looks original.


bs

Richard Bittmann wrote:

> Jorge,  It sounds like you have no cable clamp on your new block.  
> These are available from scooterworks.com.  They have a hexhead screw 
> which bears on the choke cable as it passes thru the bottom of the 
> cable clamp body under the block.  I replaced my old cables to the 
> carbs with bicycle brake cables which have the correct lead ends for 
> the block.
> Richard Bittmann BJ7 Tacoma
>
> ----- Original Message ----- From: "Jorge Garcia" <fortee9er@yahoo.com>
> To: "Austin Healey" <healeys@autox.team.net>; "Patton Dickson" 
> <kpdii@earthlink.net>
> Sent: Wednesday, January 18, 2006 9:17 PM
> Subject: BJ8 Choke cables
>
>
>> I replaced the original choke cables, including the
>> block on the firewall that holds them in place. The
>> new block has a hole for the cables to go through and
>> enough for the cable ends with the lead ends. Are the
>> lead cable ends supposed to be hammered into place so
>> that they don't move or should they be soldered/welded
>> in place?  If I don't secure them in place the choke
>> mechanism only works to set the choke by pulling but
>> it will not release the choke because when I push the
>> choke knob in the cable ends are not secured to the
>> block.
>> Thank you for your help.
>> Jorge Garcia
>
>
> Your messages not reaching the list?
> Check out http://www.team.net/posting.html
>

-- 
***************************************************************
Bob Spidell         San Jose, CA        bspidell@comcast.net
'67 Austin-Healey 3000             '56 Austin-Healey 100M
***************************************************************




<Prev in Thread] Current Thread [Next in Thread>