healeys
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [Healeys] BN2 Caster Angle

from [healeyguy--- via Healeys] [Permanent Link][Original]
To: "fredwescoe@gmail.com" <fredwescoe@gmail.com>
Subject: Re: [Healeys] BN2 Caster Angle
From: healeyguy--- via Healeys <healeys@autox.team.net>
Date: Wed, 6 Jan 2021 18:03:01 +0000 (UTC)
Cc: "healeys@autox.team.net" <healeys@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: healeys@autox.team.net
References: <7C3456D9-E760-47E9-B03E-33BB4DE8A6FD@gmail.com> <C1585EAC-1546-418D-8DA4-6C294FAE96FE@gmail.com> <CAPAC+V5HvLSRyyAXr9BBWssjUYmV70ET30mdcwE2Ud9qrOWEVg@mail.gmail.com> x64) AppleWebKit/537.36 (KHTML, like Gecko) Chrome/87.0.4280.88 Safari/537.36 Edg/87.0.664.66 
If the whole weight of the car was sitting on the bottom of the kingpins then 
we would have a bigger friction problem since there is not a supporting 
surface, in the vertical direction, between the kingpin and the stub axle 
assembly. The supporting surface is the thrust washers in the upper trunnion. 
P
_______________________________________________

Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [Healeys] BN2 Caster Angle, Bob Spidell
Next by Date:  Re: [Healeys] BN2 Caster Angle, Bob Spidell
Previous by Thread:  Re: [Healeys] BN2 Caster Angle, Bob Spidell
Next by Thread:  Re: [Healeys] BN2 Caster Angle, Bob Spidell
Indexes:  [Date] [Thread] [Top] [All Lists]