| To: | Carl Floyd <cmfloyd@chartertn.net> |
|---|---|
| Subject: | Re: Help w/Rover 3.9 piston choices |
| From: | "T. S. White" <tswrace@pacbell.net> |
| Date: | Sun, 09 May 2004 06:55:25 -0700 |
| Cc: | mgb-v8@autox.team.net, Rover V8 list <buick-rover-v8@autox.team.net> |
| References: | <004d01c4350c$cb83aae0$e87d9e18@chartertn.net> |
| Reply-to: | "T. S. White" <tswrace@pacbell.net> |
| Sender: | owner-mgb-v8@autox.team.net |
I don't know about pistons but you can always mill the heads. I took
.040 off my 289 heads and got it up to 10:1.
--
Best Regards,
Tom
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Help w/Rover 3.9 piston choices, James J. |
|---|---|
| Next by Date: | Carlisle, rshellen |
| Previous by Thread: | heat-treat castings, James J. |
| Next by Thread: | Re: finishing questions, James J. |
| Indexes: | [Date] [Thread] [Top] [All Lists] |