On 11/27/98 9:25 PM so and so (Chris Rogers) said. (And I quote:)
SNIP
> Also, how does one remove the water temp. end from
>the combo oil pressure/temperature gauge? Attempted to twist as well as
>pull to no avail. I see there are three very small screws in the side of
>the case, but decided not to try further after one half-hearted attempt.
SNIP
>Chris Rogers
>'64B and in deep on the remains of a '66B
Chris,
YOu can't remove the water temp pipe from the back of the gauge. It is a
sealed, fluid filled system. If you manage to get it apart you will have
to buy a new one. Pull the gauge from the dash and pull the pipe through
from the engine compartment.
Larry Macy
78 Midget (with both the electrical gauge and a mechanical fluid filled
temp gauge that argue about the temp)
Larry B. Macy, Ph.D.
macy@bblmail.psycha.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
In a world without walls or fences, what use do we have for windows or
gates?
|