mgs
[Top] [All Lists]

Re: Speedo Head Right Angle Drive

To: "Paul Hunt" <paul.hunt1@blueyonder.co.uk>,
Subject: Re: Speedo Head Right Angle Drive
From: Barrie Robinson <barrie@look.ca>
Date: Fri, 21 Jan 2005 09:55:00 -0800
Paul,

Looking Moss diagrams it looks like the angle drive fits on the back of the 
speedo  gauge itself.


At 08:30 AM 1/20/05, Paul Hunt wrote:
>Speedo Head Right Angle DriveI *think* it goes through the bulkhead the same
>for RHD and LHD - on top of the footrest/starter bulge in the RH footwell.  In
>the case of RHD it comes straight up and curves gently backwards straight into
>the back of the speedo.  For an LHD it curves left (facing forwards) behind
>the dash to reach the speedo, and without the right-angle drive has to take
>quite a sharp turn backwards into the back of the speedo, it also needs a
>longer cable.
>
>PaulH.
>   ----- Original Message -----
>   From: Christian, Skip
>   To: paul.hunt1@blueyonder.co.uk
>   Cc: MG Digest (E-mail)
>   Sent: Thursday, January 20, 2005 1:30 PM
>   Subject: Speedo Head Right Angle Drive
>
>
>           From what you say below, it sounds like my cable is not routed
>correctly.  I do not have the right angle drive at the top, but there is no
>sharp bend in the cable.  Here's my question - where should the speedo cable
>pass through the engine compartment bulkhead ??  Or is this cable even
>supposed to pass through the engine compartment ??  I can't imagine where it
>would go with a right angle drive attached.... right, left, down ?
>
>Your messages not reaching the list?
>Check out http://www.team.net/posting.html

Regards

Barrie Robinson
barrie@look.ca 




<Prev in Thread] Current Thread [Next in Thread>