Re: [Mgs] Heater Motor

["Councill, David" <dcouncill@msubillings.edu>]

Mine was also not overly difficult and I installed it like Mark
described. But one key factor was the fact that the engine was out of
the car as well as well as the steel hood. So I ended up standing in the
engine compartment as I wrestled the heater assembly back in place.

David Councill
67 BGT
72 B

-----Original Message-----
Subject: Re: [Mgs] Heater Motor

Gee, I didn't have any problem either removing or reinstalling the
heater
assembly.  I did have to thread the cable attached to the heater unit in
first and then go inside the car to make sure it was in the right spot
before finally pushing the unit into place, but otherwise found
reinstalling it to be no big deal.

Mark
73 MGBGT
80 Spitfire 1500
_______________________________________________

Edit your replies

Mgs@autox.team.net
http://autox.team.net/mailman/listinfo/mgs