Pssssst Hey Ed, I tried to get the "correct" mount, not available.
Larry
>>>>On 10/23/00 8:59 PM so and so (JustBrits@aol.com) said. (And I quote:)
>In a message dated 10/23/2000 5:16:58 PM Central Daylight Time,
>je.adams@worldnet.att.net writes:
>
><< should work though, 'specially if there's not
> alot of flexing where it's applied. >>
>
>Ed A., that would be a PERFECT and CORRECT statement IF everyone mounted
>their exhaust system correctly. I would wager MOST do not. When that is
>the
>cast there is SERIOUS torque applied to said manifold with the result of
>breakage.
>
>'Course it IS easy enough to not spend the $$s on "correct" mounts and
>save a
>few $$s bu purchasing "universal" mounts at Pep Boys, AutoZone, etc..
>
>In the long run, huum me thinks manifolds are EXPENSIVE and quite (trial and
>error) a PITA to "fix".
>
>Cheers............
>
> Ed
Larry Macy
78 Midget
Keep your top down and your chin up.
Larry B. Macy, Ph.D.
macy@bblmail.psycha.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a
question and you're a fool for the rest of your life.
|