... but none of that matters if you use a 1098 crank right?
Lester
On Dec 7, 2009, at 2:14 PM, Mark Haynes wrote:
> As stated, 1098 piston have a different crown height. However, 998
> piston have
> the same crown height as the 948 ones- you just have to bore the
> block by
> 0.062" for standard 998 pistons.
>
>
> Mark Haynes
> HAN6L12779
> HAN5L8016
>
> ____________________________________________________________
> Weight Loss Program
> Best Weight Loss Program - Click Here!
> http://thirdpartyoffers.netzero.net/TGL2231/c?cp=HdbKRjOpepmrH6We7OF3mAAAJz5X
> oFCg_GoYpsOBXA-
> _r2I8AAYAAAAAAAAAAAAAAAAAAADNAAAAAAAAAAAAAAAAAAAEUgAAAAA=
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as oldsaabguy@comcast.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|