tigers
[Top] [All Lists]

Re: Spare tire hold down length

To: "Jim D'Amelio" <jimdamelio@cox.net>
Subject: Re: Spare tire hold down length
From: "Kathy and Erich Coiner" <kathy.coiner@gte.net>
Date: Sun, 17 Nov 2002 11:38:13 -0800
Steve,
Could you reconcile this post with your earlier reply?

A portion quoted here for clarity:
>The Alpine did not have a hold down screw, nor did it rest on the floor.
>I stood vertically against the forward trunk wall, in the small well
>provided in the bottom, and was held with straps.
>

Erich


----- Original Message -----
From: "Steve Laifman" <SLaifman@socal.rr.com>
To: "Jim D'Amelio" <jimdamelio@cox.net>
Cc: "List, Tiger" <tigers@autox.team.net>
Sent: Sunday, November 17, 2002 11:03 AM
Subject: Re: Spare tire hold down length


> The TigersUnited.com on-line Rootes Group Parts list, Section YX - Body
> Fittings, exactly confirms Jim's numbers. Unfortunately this is a
>  special part, and not a stock bolt, so the thread dimensions are not
given.
>
> http://www.TigersUnited.com/parts_rs260/factparts.asp
>
> Steve
>
> Jim D'Amelio wrote:
>
> >The Rootes part book list three different hold downs.
> >
> >Standard wheels from Series III up to Series V B395009817 used part #
> >2227552.
> >
> >Standard Wheels from B395009818 and Tiger MKI used part number 2233108.
> >
> >Wire wheels from Series III through Series V used part # 2227553.
> >
> >Part # 2227552 was superceded to 2233108 after it's introduction.
> >
> >Jim
> >
> >
> >
>
> --
>
> Steve Laifman
> Editor
> http://www.TigersUnited.com

<Prev in Thread] Current Thread [Next in Thread>