tigers
[Top] [All Lists]

Re: [Tigers] Pulley Line-up

To: robert jaarsma <64venezia@gmail.com>
Subject: Re: [Tigers] Pulley Line-up
From: Chip Broadbooks <chip.broadbooks@gmail.com>
Date: Fri, 28 Jun 2013 11:03:20 -0400
Cc: tigers@autox.team.net
Delivered-to: mharc@autox.team.net
Delivered-to: tigers@autox.team.net
References: <001701ce73f7$c5270c30$4f752490$@gmail.com>
I used the alternator bracket from CAT. Lines up perfect.

www.reisentzrestorations.com has an aluminum version of the Mark II for
$160.
On Jun 28, 2013 8:11 AM, "robert jaarsma" <64venezia@gmail.com> wrote:

> My Tiger with a 289 needed a new water pump, so I got the one from Sunbeam
> Specialties. No surprises there. Pulley lined up perfectly with the
> balancer
> pulley.
>
> My generator was still ok, but I estimated its life would not be too much
> longer. So for a while I thought about swapping it for an alternator. It
> never really lined up perfectly. But during 20 years, never gave a problem
> either. Possibly shortened the water pumps life? .
>
> Since there was recently a discussion about alternators, I decide to take
> the plunge and make it easy on myself and I bought the Powermaster unit. My
> alternator pulley is off by >  with the water pump pulley! The way its
> pulley is mounted it has a heavy rim on the outside, which throws the
> v-groove off by maybe 1/8 . So if I turn it around, I will still be off by
> >-1/8= 5/8 . All powermaster other mounting dimensions are identical, 6
> between the ears, to straddle the original mounting arm. Now I suspect the
> original mounting bracket. 1). I could put spacer between it and the engine
> block, the bring the alternator forwards. However the dipstick doesn t give
> me much room. 2). I could bring the alternator forwards by putting the rear
> ear on the front side of the bracket and add a spacer at the front ear. But
> the alternator ear would not clear the rib of the cast Tiger mounting
> bracket. Not an elegant solution. But then, how could the original cast
> Tiger bracket be off by that much? If it was fabricated it possibly could
> bend, but not a casting. Reyer and I measured everything again tonight, but
> we can not see what s wrong. Any ideas?
>
> Just one more thing besides my electrical problem: the white wire from
> ignition switch to tach to coil resistor filled itself with Lucas smoke.
> Why?? All insulation half burned. No obvious short I could see. I am almost
> ready to take it all apart and rewire the whole car. Any body has any
> ideas?? thanks, Robert Jaarsma
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/chip.broadbooks@gmail.com
_______________________________________________

tigers@autox.team.net

Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>