Joe Curry wrote:
>
> Sumner,
> Copper tubing the size required for oil pressure gauges is so small that a
>bender (or other tools) are neither required or adequate. You will never
> make a bend sharp enough to cause a problem, so carefully bending the stuff
>manually is all you need to do.
>
> Joe
>
> Sumner Weisman wrote:
> >
> > Does anyone have any neat tricks for bending small copper (or other) tubing
> > without cracking or pinching it? I'm soon going to replace the oil line
> > that goes from the engine to the oil pressure gauge. I know they make
> > tubing benders, but are there any easy ways to do this? How about wrapping
> > it around a curved form, such as a dowel? I haven't had good luck with this
> > in the past.
> >
> > TIA.
> >
> > Sumner Weisman
> > 62 TR3B TSF263L
///
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
///
|