> Before I start pulling the driveline apart I thought I
> see If anyone has had a similar problem of a suggestion of
> where to go next. I'd appreciate the input.
The new rotors I picked up at VTR some years ago (OK, a lot of years ago)
turned out to be out of balance. I tried drilling holes
to balance them, without much success; then finally bought another new pair.
The new ones are still not perfect, but much better
than the old ones. I also found a front hub that didn't run true and skimmed
the face. Still some small vibration, but it's much
better than it was.
When I find time, I plan to use an old on-car wheel balancer (so the hubs,
rotors & drums all get balanced with the tires & wheels)
and see what that does.
-- Randall
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|