Fwd: E Motors

[ECTA845@aol.com]

Return-path: <ECTA845@aol.com>
From: ECTA845@aol.com
Full-name: ECTA845
Message-ID: <94.bcc1e72.273daa40@aol.com>
Date: Fri, 10 Nov 2000 14:45:04 EST
Subject: Re: E Motors
To: kturk@ala.net, land-speed@autox.team.net
MIME-Version: 1.0
Content-Disposition: Inline
X-Mailer: Unknown sub 171
X-Converted-To-Plain-Text: from multipart/alternative by demime 0.97c
X-Converted-To-Plain-Text: Alternative section used was text/plain

Keith, I was thinking of a Caddy Northstar with a 3 inch stroke crank.  There 
are Hot Rod parts available. Or another choice worth looking at is an LS-1 
based Vette engine with a 2.7 stroke crank with a 3.9 bore = 258CID.The Olds 
Aurora Indy engine is a good choice if you have a spare 75 LARGE to spend:-(. 
As for using a stock 305 block I would pass on it as it is a thin wall 
casting. Another problem with the small bore is they tend to shroud the 
intake valve. You could always sleeve a 350 block down to reach your desired 
bore size.



Thanks  Randy Williams (I can't believe I have the whole weekend off)