land-speed
[Top] [All Lists]

RE: Welding vs Brazing

To: "'Nafzger'" <nafzger@vtc.net>, ardunbill@webtv.net,
Subject: RE: Welding vs Brazing
From: "Albaugh, Neil" <albaugh_neil@ti.com>
Date: Wed, 8 Jan 2003 09:46:54 -0600
Howard;

I agree-- Allstate #11 & #13 are good stuff. The thin-flowing #11 is very
good where you need a thin brazing alloy that will "wick" up into a joint
between two telescoped tubes and #13 is good for fillet brazing. BTW, this
is also called "braze welding" or "nickel-silver-bronze welding".

Regards, Neil     Tucson, AZ

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.


<Prev in Thread] Current Thread [Next in Thread>