I always use silver solder (note not the softer
plumbers or electrical solder) for this type of
application. A lot stronger than regular solder.
You can braze, but the silve solder has a lower
melt point than brazing rod and you are less
likely to melt the end fittings.
Dont forget to put the nuts on the tube, and
the right way round, before fitting the nipples!
Clive
Oxford UK
==================================
----- Original Message -----
From: "Larry Shoer" <LarryShoer@comcast.net>
To: <mg-t@autox.team.net>
Sent: Thursday, June 10, 2010 4:44 PM
Subject: Re: [Mg-t] Gas line replacement
> Next we need some discussion about how to attach the copper-nickel
> tubing to the brass solder fittings at the tank and fuel pump.
>
> (I do believe a LOT of us are running around with copper fuel lines.
> Isn't that what Moss sells?)
>
> Larry
> ______________________________________________
>
> Mg-t@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/mg-t/clive.sherriff@ntlworld.com
______________________________________________
Mg-t@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|