Re: [oletrucks] bedwood milled rabbets

[jvanho01@tir.com]

Don,

If I understand your question, I would think that you could use a straight
bit of the proper width to cut these grooves, or you could use a rabbeting
bit also.

Jim V.

At 06:52 PM 2/15/99 Monday -0500, Don Kasbohm wrote:
>Ok, here's yet another question on this thread. Is there a router bit
>available to cut these into a new board! Thanks!
>Don Kasbohm
>'59 GMC 100 V8
>
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959