When removing the tranny or during it's time of stowage, at any time did you
remove the stickshift lever from the tranny?
----- Original Message -----
From: ryan.kubanoff@comcast.net
To: Dean Hedin
Cc: spridgets ; Frank
Sent: Wednesday, January 20, 2010 11:18 PM
Subject: Re: [Spridgets] shifting isssues
The concern is that its not that they are not engaging and grinding gears
(like a not fully engaged clutch) its that i cant get the stickshift itself to
move into the 1st (occasionally) or reverse position (at all). Obviously my
lack of how the transmission works is causing the problem with diagnosing
this. The car does shift into all forward gears and up until this morning
reverse with the engine running or not. The attempted failed shifts make NO
noise at all so its not grinding gear on gear.
What would block the stickshift from moving into the reverse position?
could it be the synchros that are causing the blocking?
Ryan
----- Original Message -----
From: "Dean Hedin" <dlh2001@comcast.net>
To: "Frank" <spritenut@comcast.net>
Cc: "ryan kubanoff" <ryan.kubanoff@comcast.net>, "spridgets"
<spridgets@autox.team.net>
Sent: Wednesday, January 20, 2010 10:28:16 PM GMT -05:00 US/Canada Eastern
Subject: Re: [Spridgets] shifting isssues
My apologies Frank, I did not realize you had assisted Ryan.
If it truely was a well functioning tranny previously then the only thing
I can think of is clutch adjustment.
Important point is that first and reverse have no synchros, and they are the
ones giving trouble.
----- Original Message -----
From: "Frank" <spritenut@comcast.net>
To: "Dean Hedin" <dlh2001@comcast.net>
Cc: <ryan.kubanoff@comcast.net>; "spridgets" <spridgets@autox.team.net>
Sent: Wednesday, January 20, 2010 9:44 PM
Subject: Re: [Spridgets] shifting isssues
> Dean Hedin wrote:
>> Ryan, when it finally goes into first or reverse does it "crunch" in?
>>
>> Also, what do you mean by "hobble together" ?
>> Does that mean you machined a new pilot bushing out of brass (OK) or
>> does it mean you found a piece of steel tubing that was
>> the right size (BAD)?
>
> It was a brass bushing
> His was different than what the books say (or the parts ordered) but we
> improvised.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|