Actually, in the past I've used dryer vent hose to replace the vent hose in
my MG Midget. Worked fine and held up for several years.
Paul
In a message dated 6/24/00 1:14:02 PM Pacific Daylight Time, vafred@erols.com
writes:
> Dryer vent hose is going to just melt under your hood, it is for a dryer,
> not under a car hood, be warned. You can get the complete kit from any
> mustang shop. "FT"
> >
> > OK, just got back from Home Depot. They sell 3" dia. aluminium flex
> tubing,
> > normally used for dryer venting. It's about $6 for a piece that starts
out
> > at about 2' and extends to 8', it's just perfect. I checked it out on the
> > Spit, and it fits nicely from next to the radiator all the way back to
the
> > footwell area of the firewall, on both sides.
> >
> > I'm a little hesitant about cutting 3" holes in the firewall, but as long
> as
> > I'm not going for the concours look...
> >
> > Next, need to find a grill for either end. Shoulda looked at the dryer
> vent
> > stuff. This could work rather well !!
> >
> > Ken C
Thanks,
Paul K.
|