All the kits I have seen say "Do not hone the cylinder". I have honed
aluminum cylinders and have had no problems with the results. The wheel
cylinders on Huxley was rebuilt in 1996 and have not leaked a drop since
then.
Joe
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net] On Behalf Of Dave Massey
Sent: Wednesday, February 04, 2004 11:50 AM
To: INTERNET:MotoPsyche@aol.com
Cc: triumphs@autox.team.net
Subject: Wheel Cylinders - Rebuild or Replace?
Message text written by INTERNET:MotoPsyche@aol.com
>Just how likely is it that rear wheel cylinders for 9-inch brakes on
post-60000 TR3As can be successfully re-sealed so that they won't leak?
Is
it necessarily a better bet to replace the entire unit? Any tips to
enhance a successful replacement of the seals?
<
Mayby I'm just a lousy machinist but I have never rebuilt a wheel
cylinder
that has lasted more than a few years. For my money I just buy new ones
and forget it. They don't cost that much and considering how critical
they
are for safety concerns - especially on a car lacking a dual circuit
braking system.
Dave Massey
57 TR3 (new rear wheel cylinders last year)
80 TR8 (new wheel cylinders in 2000 - no problems)
71 TR6 (new wheel cylinders in 1996 - no problems)
P.S. New hoses are a good idea, too.
|