| To: | "Don Malling" <dmallin@attglobal.net>, "Randall" |
|---|---|
| Subject: | Re: Welding clutch fork to cross shaft TR6 TR250 |
| From: | "Just Brits" <justbrits@comcast.net> |
| Date: | Thu, 8 Sep 2005 19:48:35 -0500 |
Guys!! <<it is too sloppy and does not share the load of the fork pin.>> Although mostly correct fotr the stuff (er, hardware) ya buy a HD, Lowes, Ace, Etc., methinks that as long as a SHOULDERED bolt is used........................ Ed |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Welding clutch fork to cross shaft TR6 TR250, Don Malling |
|---|---|
| Next by Date: | help identifying parts, fmags |
| Previous by Thread: | Re: Welding clutch fork to cross shaft TR6 TR250, Don Malling |
| Next by Thread: | RE: Welding clutch fork to cross shaft TR6 TR250, Randall |
| Indexes: | [Date] [Thread] [Top] [All Lists] |