healeys
[Top] [All Lists]

Re: BN2 generator attachment (stud)

To: "Allen C Miller, Jr." <acmiller@mhcable.com>, healeys@autox.team.net
Subject: Re: BN2 generator attachment (stud)
From: Blue One Hundred <international_investor@yahoo.com>
Date: Fri, 10 Sep 2004 01:22:42 -0700 (PDT)
Hi Allen -
 
Having suffered a similar problem on my BN1 thermostat housing, I have learned 
that these special studs are not available anywhere except off of old used 
Austin motors if you can find one.
 
The best fix, at least until you can find a stud, is to simply run a BSF bolt 
in there.
 
Regards,
 
Alan
 
'53 BN1 '64 BJ8


"Allen C Miller, Jr." <acmiller@mhcable.com> wrote:
I have learned, perhaps the hard way, that the generator bracket (1B 1724) is
attached to the block with four studs with washers and lockwashers. We sheared
a bolt in the forward inner hole, which is into the water jacket, and
hopefully will be able to back it out.

I've found two studs that may be correct. They appear to be BSF on the top
side and BSW into the cast iron. They are almost identical to the manifold
studs that hold the heater pipe clips and stabilizers to the floats; although
the part numbers are different in the original parts list.

Does anyone have a source for thesestuds? I'd like to use the correct
attachment vs bolts. Alternately, am I correct that the studs are BSF on top
and BSW on the bottom? (If so, at least I can use the two I have). They thread
finger tight into the holes fairly well, but the last thing I want to do is
screw up threads in the water jacket.

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8




<Prev in Thread] Current Thread [Next in Thread>