RE: Doing diagnostic work with a remote starter switch

["Larry Hoy" <larryhoy@prodigy.net>]

Andy, there should be a white wire with a red tracer running down your
fire wall on the right hand side.  It will be in a big bundle of wires.
It will have a Lucas connector in it.  Separate the Lucas connector and
fasten one of the switch wires to it, the other switch wire goes to a
12v pos source.  Now by pushing the button the engine will crank (even
with the ignition switch off).  If the ignition switch is on then the
car will start.

Larry Hoy