Check out the drawings on my web page:
They are of the rear wishbone, but the bushings and sheet metal water
shields and shims (look like large fender washers) are the same.
Mike http://pages.prodigy.net/mikeross/ updated 10/05/02
'69 GT6 convertible project
'70 GT6+ (maroon)
'70 GT6+ (green)
----- Original Message -----
From: "Jack" <firstname.lastname@example.org>
To: "spitfire maillist" <email@example.com>
Sent: Thursday, October 24, 2002 10:13 PM
Subject: trunnion bushing
> Hoping to pick someone's brain who has replaced the trunnion bushings. I'm
> about to tackle that. I've got the parts and have sort of "dry fit" them
> the kitchen table. I am concerned about exactly what to do w/ the rubber
> seals. The Haynes manual just says "fit them." Are they to be fit around
> flange of the nylon bushings or what?
> I'm also puzzled because I expected there to be a hunk of rubber w/ this
> stuff...something that fits inside the trunnion housing and around the
> trunnion bolt. The manual seems to say that this area is just filled w/
> grease. Is that right?
> 76 1500.
/// firstname.lastname@example.org mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive