>>Probably a bad sending unit.
>Will the one off my 1500 work?
Probably, but I don't know for certain.
>>Engine oil is about the same viscosity as gear oil, or slightly less.
>>It won't make the box feel stiff. Lack of lubrication on the
plastic
>>pivot ball of the shifter will though.
>Looks like I'll have to investigate the whole shifter anyway - as it
>wobbles.
I spent a lot of time cussing mine, until I cleaned and lubed up this
part. Like a whole new transmission when I was done.
>>Holes are already there. Why do you need to make new ones?
>In the carpet...
Ah, of course. I've never tried it, but I understand using a hot rod
or such to melt the hole works much better then drilling. Supposedly
eliminates the snags and runs and such.
James
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
-----------------------------------------------------
The information contained in this communication may be confidential, is
intended only for the use of the recipient named above, and may be legally
privileged.
If the reader of this message is not the intended recipient, you are hereby
notified that any dissemination, distribution, or copying of this
communication, or any of its contents, is strictly prohibited.
If you have received this communication in error, please re-send this
communication to the sender and delete the original message and any copy of it
from your computer system. Thank you.
-----------------------------------------------------
<<<<GWIASIG 0.07>>>>
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|