My manifold has an outlet, but that is where I attached the vacuum advance
tube from the distributor. Is that screwed up too?
I forgot to mention that I am missing the draft tube coming off of the
crankcase breather tube on the tappet cover (you know, the early emissions
device that gets suction from the draft blowing across the tube). What harm
am I creating without one of those? A metal replacement is really the only
solution for me because of the tubes' close proximity to the headers.
From: TeachJP <TeachJP@aol.com>
To: email@example.com <firstname.lastname@example.org>
Date: Saturday, December 06, 1997 11:25 PM
Subject: Re: Dumb Question
>If you don't connect that outlet from the valve cover you will leak oil. I
>have the same set up and you would think that oil was free the way it
>out of the engine, in several places. I just purchased the car and I am
>to tap into the intake manifold in order to set up enough suction to keep
>oil where it belongs.
>I also use permatex on the valve covers, they are the only place I'm not