spridgets
[Top] [All Lists]

Re: Ribcase gearbox question

To: "Frank Clarici" <spritenut@comcast.net>
Subject: Re: Ribcase gearbox question
From: "David Camp" <dxcamp@bsink.com>
Date: Tue, 30 May 2006 17:13:18 -0400
The problem was I had the springy thing in the wrong hole (ouch!) and the 
reverse plunger was froze. I inserted it in the right hole (with the 
appropriate sweet nothings) and unfroze the plunger and presto - I can go 
backwards!!

Thanks for the help.

Dave Camp


----- Original Message ----- 
From: "Frank Clarici" <spritenut@comcast.net>
To: "David Camp" <dxcamp@bsink.com>
Cc: "spridget list" <spridgets@autox.team.net>
Sent: Tuesday, May 30, 2006 4:05 PM
Subject: Re: Ribcase gearbox question


> Sender: owner-spridgets@autox.team.net
> Precedence: list
> Reply-To: Frank Clarici <spritenut@comcast.net>
> X-RCPT-TO: <dxcamp@bsink.com>
> Status: U
> X-UIDL: 443208254
> X-IMail-ThreadID: a7b8017800000148
>
> David Camp wrote:
>
>>  no reverse.
>
> BTDT. The little plunger gets corroded or gunked up.
> That is the reverse plunger or whatever it is called.
> If you look real close on the far right of the shifter hole you will see 
> the plunger.
> Squirt it with penetrating oil (not WD 40) And work the shifter to the far 
> right with a few good slaps. It will free itself up.
>
>
> -- 
> Frank Clarici
> Toms River, NJ
>


---
[This E-mail scanned for viruses by Declude Virus]




<Prev in Thread] Current Thread [Next in Thread>