[Top] [All Lists]

Re: Sheet metal

Subject: Re: Sheet metal
From: (Barry Schwartz)
Date: Fri, 15 Nov 1996 08:06:55 -0800
> Personal sidebar: in 1983 I went to the VTR convention in Long Island 
> (theoretically a part of the State of New York ;-) ). There I took 
> advantage of TRF's free shipping on convention sales offer to buy a 
> complete Spitfire 1500 floor pan. That had to have been an expensive 
> premium for them to offer. Even though I'm only about 3-400 miles or so 
> from Armagh PA, it must have cost a bundle to crate, put on a semi, then 
> unload to someone's pickup truck, which was how it finally got to my 
> house. And I didn't have to do a thing until it appeared in my driveway

   LUCKY you!!!  You could probably cammand a preminum for that one.  From
what I heard the last three complete floor pans TRF had were shipped to
Australia.  Can you imagine the freight shipping on that one (wonder if they
took advantage of the free shipping?)
Also on the thread of floor pans there are at least three different center
tunnel configurations that I know of, proobably another reason of using
seperate right and left panels, at least these are all the same-

Barry Schwartz (work) (home)
(San Diego)
70' Spitfire (under-going major surgery) ,  72'-V6 Spitfire (daily driver)

<Prev in Thread] Current Thread [Next in Thread>