I am replacing my clutch. I am changing the flywheel and clutch
housing back to a Series II from a Series V.
The fulcrum arm is different...not as tall, so it will accommodate
the larger clutch housing and throw out bearing.
I now have 2 piston rods to go between the fulcrum arm and the
slave cylinder. One is 4" long and one is 41/4" long measured from
the pivot pin to the end. The are not adjustable
Which one do I use?
Thanks in advance
Tony Leeming - Clutchless on Gabe
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 11:00:31 CDT