oletrucks
[Top] [All Lists]

Re: [oletrucks] The cold got to me

To: "Jhouse" <jhouse@ccsol.com>, "'dpewter'" <dpewter@msn.com>,
Subject: Re: [oletrucks] The cold got to me
From: "Jays Mail" <jaybaker@ruralnetwork.net>
Date: Sat, 17 Nov 2001 06:25:20 -0700
Freeze plug directly under the water pump in the block .
 Thanks Jay Baker
 4864 Hyline Rd
 Ontario Or, 97914
1-208-409-3213
www.expage.com/chevylikearock.com
----- Original Message -----
From: "Jhouse" <jhouse@ccsol.com>
To: "'Jays Mail'" <jaybaker@ruralnetwork.net>; "'dpewter'"
<dpewter@msn.com>; <old-chevy-truck@yahoogroups.com>;
<oletrucks@autox.team.net>
Sent: Saturday, November 17, 2001 9:15 AM
Subject: RE: [oletrucks] The cold got to me


> Is this plug on the block or on the pump.  I can see no plug.  Is it a
screw
> or what is the head format?
>
> Thanks,
> NHJim
> 45 Chevy 3104 (that is not going to the dump today;<)
>
> -----Original Message-----
> From: Jays Mail [mailto:jaybaker@ruralnetwork.net]
> Sent: Wednesday, November 14, 2001 3:52 PM
> To: dpewter; Jhouse; old-chevy-truck@yahoogroups.com;
> oletrucks@autox.team.net
> Subject: Re: [oletrucks] The cold got to me
>
>
> there is a freeze plug directly under the pump? I had to replace one of
> these in a 41 I picked up one time
>  Thanks Jay Baker
>  4864 Hyline Rd
>  Ontario Or, 97914
> 1-208-409-3213
> www.expage.com/chevylikearock.com
> ----- Original Message -----
> From: "dpewter" <dpewter@msn.com>
> To: "Jhouse" <jhouse@ccsol.com>; <old-chevy-truck@yahoogroups.com>;
> <oletrucks@autox.team.net>
> Sent: Wednesday, November 14, 2001 11:45 AM
> Subject: Re: [oletrucks] The cold got to me
>
>
> > If it's like the pumps in the later 216's, like my 49 (but not like the
> > older 235's, with the fan pellars recessed into the block), then you
have
> a
> > gasket leak EITHER where the pump attaches to the block (two ports, I
> > believe, in & out) OR the plate that is used to seal the back of the
water
> > pump casting is distressed.  If you don't see water leaking out the
front
> > (hard to see with the deeply recessed pulley that the 216's all have) OR
> > hear "scrawling" from the pump bearing/bushing, then the pump is
probably
> > not in need of a mechanical rebuild or replacement.
> >
> > Regards,
> > Doug Pewterbaugh
> > dpewter@msn.com
> > Denton, TX
> > 49 3104 216 5-window
> >
> > ----- Original Message -----
> > From: "Jhouse" <jhouse@ccsol.com>
> > To: <old-chevy-truck@yahoogroups.com>; <oletrucks@autox.team.net>
> > Sent: Wednesday, November 14, 2001 12:08 PM
> > Subject: [oletrucks] The cold got to me
> >
> >
> > > Well all summer my 46 1/2 ton was boiling over, after an hour drive.
> > > Original 216 with NO MODIFICATIONS, 65,000 miles, one rebuild with
+30,
> > new
> > > head job last summer.  It runs great in the winter and below 70
outside
> it
> > > hangs out around 175.  So I just add a 1/2 gallon of water as needed
and
> I
> > > was on my way.
> > >
> > > Now that the temp had dropped and I did not have anything in the
system
> > > beside water, I now have a stream of water going down my driveway.  I
> > > refilled the system and started the motor.  Well it still is poring
out.
> > At
> > > first I thought it was coming through the driver side of the block.
> Well
> > > now I have found it to be coming out the bottom of the water pump.
> > Between
> > > the pump and the block.  I have both a rebuilt water pump and a water
> pump
> > > rebuilding kit.  I am guessing that I should swap it out with the
> > > replacement and hope everything is ok.
> > >
> > > Any input?
> > >
> > > It looks like a simple but time consuming job - is it - any hints?
> > >
> > > Thanks,
> > > NHJim
> > > 45 Chevy 3104
> > > Hollis, NH (now it up to 55)
> > > oletrucks is devoted to Chevy and GM trucks built between 1941 and
1959
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>