oletrucks
[Top] [All Lists]

Re: [oletrucks] master cylinder

To: wayne@chevytrucks.org, oletrucks@Autox.Team.Net
Subject: Re: [oletrucks] master cylinder
From: Mask1966@aol.com
Date: Tue, 5 Oct 2004 12:16:41 EDT
In a message dated 10/5/2004 4:42:23 AM Central Standard Time, 
wayne@chevytrucks.org writes:
when mounting the master cylinder on the bracket, appears this would move the 
entire unit to the rear quiet a bit. How do you handle adding fluid as it 
appears it may be past the hole in the floorboard for adding fluid. What 
ingenious methods do 

Wayne,
  You are right, the MC no longer lines up with the factory hole in the 
floor.  I use a small plastic funnel with a short length of hose shoved over 
the 
end.  Adding small amounts of fluid and then looking to see the level will get 
the job done.  I just didn't want to cut the floor.

Mike Klepp
'48 3100 5 window
'65 C-10 stepside
Wichita Falls, TX

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959





<Prev in Thread] Current Thread [Next in Thread>