6pack
[Top] [All Lists]

Re: TR 250 Hood release cable keeps pulling out

To: jatabor@hotmail.com
Subject: Re: TR 250 Hood release cable keeps pulling out
From: jay_welch@juno.com
Date: Tue, 13 Feb 2001 11:36:26 -0500
I built the simple hood release described in the link below.  Took about
20 minutes and it works excellent.  I straightened a paint can handle and
measured so that it just gets through into the passenger compartment.  I
terminated it with a small loop  The force needed to open the hood now is
about 25% what it takes to pull the cable.  I just bend over into the car
and pop it open.  I highly recommend it to anyone and kudos to the person
that designed it.

http://www.clark.net/pub/rweeks/hood_release.html

Good luck,
Jay Welch - Abington, MA
1971 TR6 project
1973 TR6 driver
Member "Cape Cod British Car Club"

=====================================

On Tue, 13 Feb 2001 09:18:49 -0500 "James A. Tabor" <jatabor@hotmail.com>
writes:
> Neil,
> 
> Here is yet some more advice buddy.
> i actually have had a cheap handle BREAK off and freaked out!
> luckly i was able to put vise grips on the cable to opent he darn 
> bonnet.
> anyway, sounds like you are getting good advice and i just wanted to 
> through 
> in a wonderful tip from the VTR site.
> go to: http://www.vtr.org/maintain/stuck-bonnet.html
> 
> cheers!
> 
> -james
> 
> >From: Neil Moran <nmoran@freitaslaw.com>
> >Reply-To: Neil Moran <nmoran@freitaslaw.com>
> >To: "'6pack@autox.team.net'" <6pack@autox.team.net>
> >Subject: TR 250 Hood release cable keeps pulling out
> >Date: Mon, 12 Feb 2001 14:41:30 -0800
> >
> >I am writing to ask for advice on how to install a new bonnet 
> release
> >cable on my wife's TR250 so it lasts this time.
> >
> >I think I must have installed the hood (bonnet) release cable
> >incorrectly last year. Symptom is: Handle and cable pull out about 
> 6
> >inches and release is barely activated. The engine compartment end 
> of
> >the release cable is secured to the release unit.
> >
> >I just ordered new inner/outer cable assembly, as well as new 
> bonnet
> >release unit (the locking unit on the firewall), and want to 
> install it
> >right this time. I also ordered the auxiliary "emergency hood 
> release"
> >cable from Moss, as a backup.
> >
> >Any "hints from Heloise" would be much appreciated. I sure hate it 
> when
> >the cable release failed a year ago and I had to remove the 
> headlamps,
> >the bonnet hinges, and take the entire bonnet off to get the darn 
> thing
> >open again. I nicked the new paint in the process, too.
> >
> >Thanks for any help!
> >
> >Neil Moran
> >San Rafael, California
> 
> _________________________________________________________________

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:

<Prev in Thread] Current Thread [Next in Thread>