Hallo,
Just got done doing the waist seals on the passenger door.
Thanks to the archive, I had some problems, but nothing major.
They're in, and are a huge improvement.
However (there's always something, eh?), the window won't roll down without
grabbing the outer seal and taking it down with itself into the door.
Putting some water on the window-seal interface solves this.
The seal is visibly installed correctly; fits flush, all 7 clips, and seals
the window very nicely.
Any ideas on how to get the flippin' window to not grab the outer seal? I
really don't want to trim a 1/32 off the seal.
John
'75 Spit
|