John,
Did you ensure that the clips are installed in the recessed areas of the seal?
My trick for making sure they are in the right place is to lay the strip on top
of the door opening and using pieces of plastic
electrical tape, mark where the indentatons are. THen you can use them as a
guide to install the clips. They will easily come off
without harming the paint.
Regards,
Joe
JM Weber wrote:
>
> Hallo,
>
> Just got done doing the waist seals on the passenger door.
> Thanks to the archive, I had some problems, but nothing major.
> They're in, and are a huge improvement.
>
> However (there's always something, eh?), the window won't roll down without
> grabbing the outer seal and taking it down with itself into the door.
> Putting some water on the window-seal interface solves this.
>
> The seal is visibly installed correctly; fits flush, all 7 clips, and seals
> the window very nicely.
>
> Any ideas on how to get the flippin' window to not grab the outer seal? I
> really don't want to trim a 1/32 off the seal.
>
> John
> '75 Spit
|