spitfires
[Top] [All Lists]

Re: wheel bearings AND u-joints

To: Richard B Gosling <Gosling_Richard_B@perkins.com>,
Subject: Re: wheel bearings AND u-joints
From: Kevin Rhodes <krhodes1@maine.rr.com>
Date: Mon, 16 Jul 2001 11:17:40 -0400
I will add that don't depend on the clicking noise getting worse as a 
warning sign. My car never clicked while in motion - I had a single "clack" 
noise when starting off. When I took the halfshaft out, I found the needles 
completely gone from one of the cups! The inner part had worn the cup badly 
and it was obviously near complete failure.

Kevin @ Freddy


At 09:33 07/16/2001 -0500, Richard B Gosling wrote:
>Brad,
>
>DO NOT delay replacing dodgy UJs!!!!!  Twice now I have thought, on a Tuesday,
>  "Oh, I'll leave it to the weekend when I'll have a little more 
> time".  Twice,
>  before the week was out, I have had the UJ disintegrate on me, while driving
>  along at 70 mph.  It was very, very scary, as I had very limited control 
> over
>  the car's direction, since one rear wheel was flopping freely all over the
>  place.  You would think I'd learned the first time!  I was very fortunate on
>  both occasions to guide the car more or less to the edge of the road without
>  hitting anything.
>
>Get underneath the car and check your UJs.  If there is a problem it should be
>  quite apparent - check for free play by turning the prop-shaft and
>  watching/feeling for relative movement at the UJ, and also grab the 
> half-shaft
>  and try to shake it.
>
>If either UJ is dodgy, allow a couple of hours (each) for replacement.  I have
>  written up the procedure on Jeff McNeal's Totally Triumph Network - 
> check out
>  http://www.ohms.com//spitfire/dcforum/DCForumID45/26.shtml#
>
>Richard & Daffy

///  spitfires@autox.team.net mailing list
///  To unsubscribe send a plain text message to majordomo@autox.team.net
///  with nothing in it but
///
///     unsubscribe spitfires
///


<Prev in Thread] Current Thread [Next in Thread>