Dave -
Yep, probably the worst design flaw on a healey.
wrong shock mounts.
The trick with them is to tighten them down with mega
torque. It actually works... they have to be very
tight but it will hold. If you can use a nylock nut
on it, that should help it from getting loose.
Don't bother trying to fix the oval hole problems, it
won't make the problem going away. Only mega torque,
checked regularly, will prevent the problem from
arising again.
Not much else you can do about it aside from putting
udo putzke's rear shock kit on it.
Cheers,
Alan
'53 BN1 '64 BJ8
--- HealeyBN7@aol.com wrote:
> I recently noticed that the rear shock mounts on my
> BN7 have the shock
> mounting holes worn oval. I remember reading that
> the holes in the shocks might
> do this, but don't recall any discussion about the
> mounts.
> I this a problem that requires fixing? Will the
> oval holes let the shocks
> potentially move up and down under load? Or, can I
> clamp the shocks well
> enough with thru bolts and mega torque?
> Or, is there a good fix? Perhaps a plate with the
> correct diameter holes,
> that would be sandwiched and welded behind the
> current mount? Can these be
> purchased? I don't recall seeing them anywhere.
> Thanks!
>
> Dave
> 61 BN7
|