Hello, everyone.
For some reason, I can't seem to search archives. Even "windshield" gets me
zero results.
Does anyone have suggested procedures for getting the upper and lower seals
into the lock-grooves in the windshield frame? ...Has anyone used silicone
grease or silicone spray to give the rubber a helping hand?
Lastly, where does one insert the top seal to start, ...at the bottom, working
it up one side and then over the top?
Thanks, everyone.
Terry Smith, '59 TR3A
New Hampshire
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|