> As I slowly
> accelerate, it will continue to stumble or miss, until it hits about
> 2000 rpm, then it will take off like it should. Just criusing at
> around 1500 -2000, it will stumble, also.
Just a thought, have you double-checked the point gap since the problem started
happening ?
I had a similar problem once on a non-LBC; turned out the root cause was that I
had forgotten to lube the point cam. The dry cam would erode the rubbing block
away, and the lack of point gap would make it idle poorly. At higher rpm it
would seem to run OK.
Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|