6pack
[Top] [All Lists]

Re: Cam bearing bore size

To: Don Malling <dmallin@attglobal.net>
Subject: Re: Cam bearing bore size
From: Mitchel Seff <ms6453@optonline.net>
Date: Fri, 22 Nov 2002 11:52:44 -0500
Hey Don-The VIS kit is no longer made but a local member of the Long 
Island Triumph club is reproducing a kit very similar. You can contact 
him at Opntop@aol.com , His name is Sal .
He supercharged his TR250 & it is running well but is dealing with 
detonation due to compression over 7.75:1. You may be able to tune this 
out with water injection & timing but it's asking allot for a 
non-computer management car. An MSD w/boost ign retard may help as well 
but I doubt it can be eliminated.
If your considering it , a TR low comp head can be had pretty easily. 
There's very little you can do performance wise on the car that will 
compare with forced induction & still remain docile for a daily driver.

-- 
Mitch Seff
Oceanside, N.Y.
75 TR6
http://www.angelfire.com/ny4/triumph5/ 

<Prev in Thread] Current Thread [Next in Thread>