RE:wooden Dashes

[Tony Rhodes <ARhodes@compuserve.com>]

Ian,

In my opinion, the contact cements are not up to the task either.  They
get pretty soft in the heat, expecially a GT6.  It is better to use a
2 part resin cement.  I used an acrylic urethane automotive clearcoat
for the finish.  It is CLEAR, not yellowish, waterproof, very UV resistant.
Just what you need for an exposed surface such as a dash.  Plus, it
takes a better shine than any spar varnish I have seen.

As for the source of veneers.  Check www.wood-veneers.com

-Tony