I would overlap, unlesss you're quite talented with the mig. It is very easy to
burn holes through when you butt weld and then it is hard to deal with.
Either way, just do about an inch and then move to a very different area
otherwise it will burn through, or at least warp, due to the heat building up
in that area.
Regards,
Jim Wallace
=======================
Hello All,
I am getting prepared to fix another project and need to know one thing.
What is the way you mig weld in a patch panel, like a lower fender.
Butt weld or overlap with a flange?
I'm welding on my rusty little Midget.
TIA
Cheers,
Mike Thompson
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|